How to build a Knock Down Sawhorse Cutting Grid
Cutting down full sheets of plywood with a circular saw has always been a bit awkward. I usually lay the plywood sheet on supports on the floor and then have to crawl around to make the cut. But recently, I came up with a solution that makes the process a lot easier...
|
| |
How to build a Knock Down Workbench
As a school woodshop teacher, I must often solve problems on the spur of the moment. Thatng and, above all, absolutely rigid. When all the elements for a simple, bolt-together frame came together in my mind, I hit my palm to my brow. It seemed so obvious. I wondered why I hadn...
|
| |
How to build a Knockdown Sawhorse
A set of sawhorses always comes in handy until you put them away. Theyre hard to stack, and they take up valuable space. So I built a pair of sawhorses that knock down for storage. Besides saving space, these sawhorses can be assembled (or taken apart)....
|
| |
How to build a knock-down worktable
This is a knock-down worktable. It's always handy to have an extra worksurface when assembling or finishing a project. This table can be assembled or taken apart in less than a minute, then stacked flat against a wall for storage. Standard (ft and ins) dimensions....
|
| |
How to build a Ladder Stairs
This free farming construction plans and projects information is courtesy of the North Dakota State Univ. web site. Follow the instructions on that page to quickly find the plan number. This plan number is 5697...
|
| |
How to build a Laminated Mallet
A wooden Mallet, for smacking chisels and the like...
|
| |
|
How to build a Large Sheet Crosscutting
Crosscutting large sheets of plywood on the tablesaw can be difficult. Here is a solution from Amy Kendall / Milwaukee, Wisc...
|
| |
How to build a Large Work Table
This is a huge worktable that you can make in a few hours. It is a very straightforward layout...
|
| |
How to build a Lathe
The woodturning lathe described here and pictured above is the 4th homemade lathe that I will have built. The frame should be constructed of hardwood (maple is excellent but expensive)....
|
| |
How to build a Lathe - Heavy Duty Workstand
A lathe needs to be securely mounted, especially if you are going to do some serious work with large out of balance pieces. There are a number of approaches to making a solid lathe stand, one is to weld up some steel channel or angle which is anchored to the floor, another is to fabricate a stand fr...
|
| |
How to build a Lathe - How to Build The Workstand
By Robert Lanham - Each leg of the lathe stand consists of two plywood panels cut from one sheet 24...
|
| |
How to build a Lathe Bowl Bars
Large diameter bowl turning attachment for Poolewood PW28/40 lathe. This attachment has some advantages over the original LD stand. The main ones are that much less space is required to the left of the lathe and the stand can be detached and stored where it is not in the way. In conjunction with the...
|
| |
|
< Previous
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
Next >
|
