How to build a Slipping Edges
By Mike Hofer / Rosetown, Sask. - Sharp edges and thin laminates have a way of slipping under the tablesaw fence and ruining a project...
|
| |
How to build a Sloop Mirny
This ship building model plan is a download plan that is in an exe file format...
|
| |
How to build a Solid Wood - Technique Edgebanding
A common way to cover the exposed edges of plywood in a woodworking project is with solid-wood edgebanding. The problem with this technique, however, is that it always requires some fussing around. To streamline things a bit, I began to take a different approach when applying edgebanding....
|
| |
How to build a Solid Wood Outdoor Occasional Table
Plan to build a solid wood outdoor occasional table....
|
| |
How to build a Space Saver Workbench
Hereabout 72 inches long by 13 inches deep by 34 inches tall. 8 pages....
|
| |
How to build a Spar - Made Inexpensively Plane
There is a less expensive way to a high-quality end, and that is converting old flea-market woodies. Auburn, Ohio Tool, Fulton, and dozens of other 19th-Century manufacturers competed hard with each other in quality and value. These planes are generally beech with thick, tempered cast-steel ironse o...
|
| |
|
How to build a Speaker Stand with Hidden Storage
Wood selection makes all the difference in this project. Straight-grained pieces emphasize the stand...
|
| |
How to build a Spindle Sander Jointer
At one time I didnt have a jointer in my shop. So I came up with a way to use my oscillating spindle sander to put a smooth, straight edge on a board....
|
| |
How to build a Spray Adhesive Self-contained Workbench Drawer
Keep the mess confined with a handy drawer that pulls out to support patterns and catch overspray....
|
| |
How to build a Spring Clamp Corner Clamping
I clamp hardboard pads to the workpieces before applying the springs as shown to prevent dents...
|
| |
How to build a Spring Loaded Hold-down Jig
We often use a router table for cutting joints such as rabbets and dadoes. One of the secrets to routing an accurate joint is to make sure the workpiece is pressed firmly against the router table top...
|
| |
How to build a Square Turning
First we will mount a waste block on the screw chuck. You could also use a small face plate, but I find this less time consuming, and this Glaser screw chuck works real well....
|
| |
|
< Previous
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
Next >
|
